The difference between traditional wiper and boneless wiper
Car wiper is an indispensable part of the car dealer. In addition to the cleaning effect, it also protects the driving sight to ensure the safety of driving. As one of the most important parts on the car, the wiper is from traditional wiper to today's boneless wiper, regardless of the material. Or the function is changing. A good wiper can keep you in good view. In fact, most people know that the boneless wiper is better. So where is the good? What is the difference compared with the traditional wiper? Give it to everyone today. Explain it.
Traditional wiper
The conventional wiper presses the wiper blade onto the window glass through the support points on the skeleton to average the pressure at each support point on the wiper blade. However, the structure of the traditional wiper inevitably has multiple pressure points, which has been unable to adapt to the mainstream design of the modern windshield windshield. Therefore, after using the bone wiper for a period of time, the friction noise is likely to be large, and it is not easy to scrape impurities, water marks and the like.
Boneless wiper
Boneless wiper blades are relative to conventional wiper blades with metal brackets. The main difference between the two is in the work pressure: there is a bone wiper blade is difficult to withstand greater pressure. The steel sheet in the boneless wiper uses a whole set of conductive steel strips to disperse the pressure, so that the parts of the wiper blade are evenly stressed to reduce the effect of water marks and scratches. The outer layer of the steel sheet is coated with an electroplated layer to make it more resistant to rust.
The boneless wiper is simple in design, light in structure and extremely light in weight, which further extends the life of the wiper motor of the car by more than 2 times. The boneless wiper does not need to replace the wiper arm, and only replaces the traditional skeleton wiper blade of the original car, which is more economical. more convenient.
Wiper daily maintenance skills
1. Do not dry, do not save the dust on the glass. Do not save the glass water. The debris in the front gear is not as simple as the eyes see. It is easy to scratch the glass without water.
2. Avoid long-term exposure, exposure is the culprit of the most direct damage to the wiper.
3. Regularly clean the rubber strips and clean them regularly to avoid excessive corrosion of the wiper blades.
4. When cleaning in winter, it is recommended to remove the snow and sand before using the wiper. Otherwise, the surface swing will cause deformation and damage to the wiper glass. There is also a more effective way to warm the car and then open the wiper after the snow melts. .
Since the height of the filling is close to the tower top, the water eliminator does not occupy much space, and the overall height of the cross-flow tower is small, which makes it relatively compact compared with counter flow type, and therefore lower air inlet speed and power consumption as well.
The cross-flow tower adopts a water distribution system that will let the water drop fall naturally by gravity. Thereby, water distribution holes are not easy to be blocked, as water distribution is even and maximizes the performance of the tower fillings. The inspection manhole also enables routinely maintenance without machine shutdown.
A lower part of the cross-flow tower filling is submerged in the water, so that the water flows through the surface of the filling and directly falls into the below tank, making low noise.
The cross-flow tower fan is located in the middle of the Cooling Tower, while the filling, on both sides of the tower. So the amount of splashing water is very small.
Cross Flow Cooling Tower,Cooling Tower Cools Water,Induced Draught Cooling Tower,Induced Draft Cross Flow Cooling Tower
Guangdong Jiema Energy Saving Technology Co.,Ltd , https://www.jmheatexchanger.com