Ito generator set features high quality, low fuel consumption, low noise, high output power, and reliable performance. After major repairs, it is generally filled with water, engine oil, fuel, etc., and all the preparation work can be started. If the fuel system is equipped with a super-stop, press the "Reset" button before starting. The following is a brief introduction to the general start-up procedure after the overhaul of Ito's generator set by Ito Power.
Ito generator set
1. Put the throttle in the idle position. Note: To prevent damage to the turbocharger, do not accelerate the generator set to more than 1000 r/min until the oil pressure gauge reading has reached normal pressure at idle.
2. Open the manual throttle on the fuel pump. The electric throttle valve only comes into play when the "switch" closes.
3. Press the start button or turn the "key switch" to the start position.
4. When the electric valve fails, use the manual button on the front of the electric throttle to open the throttle. When using manual, turn the button clockwise. After the electric valve is repaired, turn the button back to its original position. In order to prevent damage to the starter motor, the starting time of the starter motor must not exceed 30 s. If you cannot start the diesel engine within 30s for the first time, wait for 2 minutes before starting it for the second time.
5. Put the throttle on a low idle position and start the starter. After the diesel engine is started, it must be operated at idle speed for 5 to 10 min. Check the oil pressure and the presence of fuel, oil, water and air leaks. Note: Before running-in, it is not allowed to increase the speed of Ito generator set to more than 1000r/min, and do not allow the generator to run at idle for too long.
Hydraulic Metal Baler
Hydraulic Metal Baler is specially used to baling various scrap metal materials and compress them into rectangular, cylindrical, octagonal, etc. The metal scraps that can be processed include scrap metal materials, metal shavings, rotating scrap metal materials, scrap steel bars, scrap aluminum profiles, scrap metal home appliance shells, scrap car shells, etc. The main cylinder pressure of our hydraulic metal balers ranges from 63 tons to 2000 tons and is divided into more than ten grades. Customers can choose the appropriate type of metal BALER according to their needs. The size of the material box and the size of the bale of the metal baler can be designed and produced according to customer needs.
Hydraulic Metal Baler,metal baler,scrap baler,baling machine
Jiangsu Dalongkai Technology Co., Ltd. , https://www.dlkscrapbaler.com