Tanker trucks are dangerous goods and should be handled with special care. For the sake of safety, we will introduce the tank truck drivers to the following operations:
Article 1 is to do a good job in the cleaning of tank trucks, to ensure the safety and health of oil tanker cleaning personnel, to constantly improve the technical level of tank truck cleaning, and to prevent accidents of all kinds. According to the principle of "prevention first", Special regulations are established.
Article 2 Tank truck cleaning is as follows:
— The tank cleaning cycle is generally three to five years.
The second is when the tanker changes to another type of oil, it should be cleaned.
Third, leakage or other damage to the tanker needs to be checked for emptying or hot work.
Article 3 This regulation is applicable to the cleaning of oil tanker trucks at various levels. Gas stations and other oil business units can also refer to implementation.
Article 4 shall fully carry out inspections and preparations for safety measures for tanker trucks and materials, tools, and equipment.
Tanker General Safety Regulations Article 5 The tank cleaning operation department shall formulate concrete and feasible tank cleaning plans and safety measures according to different conditions at the job site.
Article 6 The commander of the clearing tank must visit the site during the clearing operation to solve and solve the problems found in time.
Article 7 After clearing the plan and safety measures of the clearing tank, they shall be approved by the competent manager and executed.
Article 8 Prior to the canning operation, relevant personnel shall be given pre-job education on safety and related operating techniques according to the division of labor, and they shall be post-approved only after passing the assessment.
Article 9 Where an operator enters the tank to inspect or perform work, a full-time guardian shall be provided outside the tanker's manhole, and a guardian shall not guard two operating points at the same time.
Article 10 Security (Guardian) staff shall strengthen the on-site safety inspection tour, and shall have the right to stop illegal command and illegal operations and report the relevant leaders in a timely manner.
The person in charge of the 11th class (team) and the security (guardianship) staff should do a good job of on-the-spot safety inspection, inventory of personnel and their tools and equipment.
Article 12 Workplaces shall determine the safety distance, set up security landmarks or fences, and shall have special persons responsible for guarding the security landmarks or fences provided.
Article 13 In order to ensure safety, the entry operation must be implemented in the entry operation.
Article 14 In order to prevent canisters from poisoning, they must:
When the concentration of oil and gas is 4 to 40% of the lower limit of explosion of the oil product, the operator entering the tanker must wear an isolated gas mask.
2. When the concentration of oil and gas exceeds 1% of the lower explosion limit of the oil and is less than 4%, operators are allowed to enter the tank for a short period of time without wearing breathing apparatus, but they should wear a respirator and should not exceed 15 per operation. Minutes; At the same time, repeat up to four times per working day at intervals of no less than one hour. At this concentration, similar filter-type breathing apparatus (such as a poisonous gas mask) can also be used, but its oxygen content in the gas space should not be less than 18%.
3. When the concentration of oil and gas is lower than 1% of the lower explosion limit of the oil product, it is allowed to operate for eight hours without protective measures.
Article 15 The supply of the isolated breathing apparatus may be based on different conditions such as self-priming air, manual air supply, electric fan air supply, compressor air supply, and self-contained compressed air type.
Article 16 According to different places, the selection of anti-virus appliances and protective equipment, its size should ensure that the appropriate wear, good performance, must be strictly observed in the use of tanker operations of the various matters. The inner and outer surfaces of breathing hoses should not be contaminated with oils, etc.
Automatic Sliding Door Operators
High quality door residential automatic door opener
Carton+Foam+Bubble Bag and Pallet
Safety & Operation Devices of High Speed PVC Roll up Door:
In consideration of operation safety for high speed PVC roll up door, we provide the photo cell, and wireless safety airbag device as the standard safety device; And to enrich the operation methods of the high speed door, various options are provided such as manual button, transmitter, control box, radar sensor and inductive loop device. Different styles of transparent window are also available for better vision view.
Varied Running Speed of High Speed PVC Roll up Door:
Running speed of High Speed PVC Roll up Door is adjustable: Opening speed from 0.80m/s to 2.0m/s, and closing speed from 0.6m/s to 1.0m/s. Running speed adjustment can be achieved through inverter inside the control box, t to meet the actual needs.
Driving System of High Speed PVC Roll up Door:
Driving system is the core part for the high speed roll up doors. For the motors, we can provide multiple options for different demands, brands including SEW, SIEMENS, SNMA, SEJ and Servo Motor; All the motors are provided with manual brake, that offers emergency operation under power failure. Furthermore, motor power can be applied based on the real door size, in supply voltage 220V single phase and 380V three phase.
sliding door operators, automatic door motor opener, door accessory ,automatic door operators,fast door accessory
SHENZHEN HONGFA AUTOMATIC DOOR CO., LTD , https://www.hongfafrud.com