Stainless steel gear pump structural features
As the stainless steel gear pump to the transmission of the sliding bearing lubrication, it should be based on different media and the use of conditions, the use of different materials made of bearings.
two. Isolator Sleeve When using a metal isolator, the isolator is in a sinusoidal alternating magnetic field that induces eddy currents and converts it into heat in a cross section perpendicular to the line of magnetic force. The eddy current is given by: where Pe-eddy current; K-constant; n-pump rated speed; T-magnetic drive torque; F- pressure inside the spacer; D- spacer inner diameter; resistivity of a material; Tensile strength. When the pump is designed, n, T is given conditions, to reduce eddy current only from the F, D and other considerations. Selection of high resistivity, high strength non-metallic materials made isolation sleeve, the effect of reducing eddy current is very obvious. three. Cooling lubricant flow control Stainless steel gear pump operation, you must use a small amount of liquid on the inner rotor and the isolation sleeve between the annular region and the sliding friction bearing pair was washed and cooled. Coolant flow is typically 2% to 3% of the pump design flow, and the annulus area between the inner magnet rotor and the isolation sleeve generates high heat due to eddy currents. When the cooling fluid is not enough or flushing hole poor, blocked, it will lead to the medium temperature is higher than the permanent magnet operating temperature, the magnetic rotor gradually lost magnetism, the magnetic actuator failure. When the medium is water or water-based liquid, the annulus area can be maintained at 3-5 ℃. When the medium is hydrocarbon or oil, the annulus area can be maintained at 5-8 ℃.
four. Permanent magnets Permanent magnet made of rare earth permanent magnet has a wide range of operating temperature (-45-400 ℃), high coercive force and good anisotropy in the direction of magnetic field, and will not demagnetize when the same pole is close Phenomenon, is a good source of magnetic field.
Fives. Protection When the driven parts of the magnetic actuator operate under overload or the rotor is stuck, the main and driven parts of the magnetic actuator will automatically slide off to protect the pump. In this case, the permanent magnet on the magnetic actuator will generate eddy loss and magnetic loss under the action of the alternating magnetic field of the active rotor, causing the temperature of the permanent magnet to rise and the magnetic actuator to slip off.
About Silicone Cup
Custom Silicone Cup is one of our Silicone Kitchenware,it including Silicone Wine Glasses,Silicone Beer Glasses,Silicone Tea Cup.They are made of silicone,and it's more durable than normal cup,and you can have your design on Silicone Wine Cups,Silicone Beer Drink Bottle,Custom Silicone Tea Cup.There are many design you can choose,and hope can receive your idea on products.
Product introduction:
1.Product name:Silicone Wine Glasses,Silicone Beer Glasses,Silicone Wine Cups,Silicone Beer Drink Bottle,Custom Silicone Cups,Silicone Tea Cup
2.Place of origin:Guangdong China
3.Color:any pantone color
4.Effect:Any effect according to customer's requirement
5.MOQ:500pcs.
6.Package:1 pcs/opp,customized design is available.
7.Design:Customized/stock
8.Certification:FDA,LFGB,SGS,ROHS,etc.
9.Usage:Use to Drinking Water/Tea/Coffee/Other Drinks
10.Silicone Cup photos for reference.
Silicone Cup,Silicone Wine Glasses,Silicone Beer Glasses,Silicone Wine Cups,Silicone Beer Drink Bottle,Custom Silicone Cups,Silicone Tea Cup
Dongguan OK Silicone Gift Co., Ltd. , https://www.dgsiliconebabyproducts.com